Sep 28, 2011 · MCLK is used as clock source for the CPU. SMCLK is usually a high frequency clock and it is used for peripheral modules (e.g. Timers, serial ...

Nov 19, 2013 · Hi all,. I'm using an msp430g2553. I'm currently sourcing Timer A and ADC10 from SMCLK. I am unclear about what all of the clocks are used for.

I am watching ACLK on PJ.3 with a good quality oscilloscope. If I apply a significant level of EMC (from an EMPulse - so actual levels unknown) above the ...

i'm using the MSP430F5438A and i'm trying to set up different frequencies for the three different clocks MCLK SMCLK and ACLK. I'd like to have 8MHz for the MCLK ...

Sep 15, 2023 · Select ACLK as the clock source of timer Timer0 and find... **Attention** This is a public forum. State Resolved; Locked Locked; Replies 3 ...

I am trying to make a system where I want to use the ACLK/n as an output of the MCU. ACLK is sourced from XT2, divided by 32, and this ACLK is then divided by 2 ...

I am using the MSP430G2231 and want to know how I can make ACLK appear on P1.0. Do I need to write code or?? I am using CCS V4.2 with assembly language ...

Open your part datasheet and look towards the very back. It will describe what each of the pins can do and how to configure them. You will have to find the ...

Jul 22, 2014 · Hey guys, I'm trying to get a simple LED to flash on/off following Timer A saturation with LFXT1 sourcing ACLK in LPM3.

I want to change my current external clk or ACLK to a higher crystal like: 4 or 8 Mhz. Based on the electrical characteristics (SLAS396C - Page 17), the maximum ...