Jul 22, 2014 · Hey guys, I'm trying to get a simple LED to flash on/off following Timer A saturation with LFXT1 sourcing ACLK in LPM3.
CTR via TIMx.CCCTL.LCOND is not work for period capture. It will have influence on "Period Capture" mode and "Combined Pulse Width and Period Time" mode ...
Missing: url 356877/ aclk- continuous- lpm3
MSP low-power microcontroller forum. 51,634 questions and discussions. Nick Richards. RE: MSP-EXP430F5529LP: MSP-EXP430F5529LP Eval kit communication issue ...
Sep 22, 2023 · The clock source will still change though as you drop into the lower power modes. When you are being pulled back into run mode by the debugger ...
Missing: url 356877/ aclk- continuous- lpm3
Apr 2, 2013 · The MSP430 has one active mode and five software selectable low-power modes of operation. An interrupt event can wake up the device from any of ...
Missing: url 356877/ continuous-
Jan 10, 2018 · Part Number: MSP430FR4133 Hello this is just a general question regarding timers for the MSP430 FR4133 as I am not sure what is the correct ...
Missing: url 356877/ continuous- lpm3
Dec 13, 2018 · A timer interrupt wakes the microcontroller up and it reads from the sensor again. The sensor output is connected to Pin 1.1. Pin 1.0 is used to ...
Missing: url 356877/ continuous-
Regarding the type of communication interface between the devices, are you looking for a master-slave type interface, or a peer-to-peer? I'm also not quite ...
Missing: 356877/ aclk- continuous- lpm3
People also ask
How much current does MSP430 consume?
What is the active mode of MSP430?
What is the difference between timer A and timer B in MSP430?
In order to show you the most relevant results, we have omitted some entries very similar to the 8 already displayed.
If you like, you can repeat the search with the omitted results included. |